DJI Mavic 2 Pro и Zoom инструкция на английском - страница 58

Предыдущая страница (57)
Страница из 67
Следующая страница (59)
Предыдущая страница (57)
Страница из 67
Следующая страница (59) 
                    Mavic 2 Pro/Zoom User Manual
Starting/Stopping the Motors
Starting the Motors
A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the inner or
outer bottom corners to start the motors. Once the motors have started spinning, release both sticks
simultaneously.
                                                         OR
Stopping the Motors
There are two methods to stop the motors:
Method 1: When the aircraft has landed, push and hold the left stick down. The motors stop after three
          seconds.
Method 2: When   the aircraft has landed, conduct the         same CSC that was used       to start the motors, as
          described above. The motors stop immediately. Release both sticks once the motors have
          stopped.
                                                                             OR
                        Method 1                                             Method 2
Stopping Motors Mid-Flight
Stopping the motors mid-flight will cause the aircraft to crash. The motors should only be stopped mid-
flight in an emergency situation such as if a collision has occurred, a motor has stalled, the aircraft is
rolling in the air, or the aircraft is out of control and is ascending/descending very quickly. To stop the
motors mid-flight, use the same CSC that was used to start the motors.
Test Flight
Takeoff/Landing Procedures
1. Place the aircraft in an open, flat area with the Aircraft Status Indicator facing towards you.
2. Turn on the aircraft and the remote controller.
3. Launch DJI GO 4 and enter Camera View.
4. Wait until the Aircraft Status Indicator blinks green indicating that the Home Point has been recorded
   and it is now safe to fly.
5. Gently push the throttle stick to take off or use auto-takeoff.
6. Pull the throttle stick or use auto-landing to land the aircraft.
7. Turn off the aircraft and remote controller.
58    © 2018 DJI All Rights Reserved.