Razor E300 инструкция на русском - страница 8

                    Repair and Maintenance
10 Install the axle adjusters       11 Tighten both axle adjusters       12 Tighten the brake housing
and axle nuts. Tighten until they    the same number of turns to fine-   anchor securely. Test ride.
just barely hold the hardware        tune the tension on the chain and   Readjust as needed.
in place.                            center the wheel.
13 Replace the chain guard.
q Front Tire Replacement
Tools required: two (2) 17mm wrenches and a flathead screwdriver.
                                                                                                             Right Side (Throttle)
                                                               9-1                                           9-3 - Spacer
                                                           9-3                                               9-2 - Washer
                                                                   9-29-2                                    9-2 - Washer
                                                                                                             9-1 - 17mm locknut
                                            9-6                                                              Middle
                                       9-5                                                                   9-6 - Front axle bolt
                                   9-1
                                               9-2
                                           9-2                                                               Left Side (Brake)
1 Using two 17mm wrenches,         2 Remove wheel and install                                                9-5 - Spacer
loosen the front axle bolts by     replacement.                                                              9-2 - Washer
turning the wrenches counter                                                                                 9-2 - Washer
clockwise.                                                                                                   9-1 - 17mm locknut
                                                                       7