Razor E300 инструкция на русском

Repair and Maintenance
q Chain and Rear Tire Replacement
Tools required: Phillips screwdriver, 10mm wrench, two (2) 8mm wrenches, and two (2) 17mm wrenches.
1 With a Phillips screwdriver, 2 With a 10mm wrench, 3 With two 8mm wrenches,
loosen the two screws and loosen the brake cable anchor loosen brake housing anchor
remove the chain guard. and disconnect the cable. and disconnect. Keep the spacer
and bolts together.
Right Side (Throttle)
(Long) spacer
Washer (thick)
Washer (plate cut)
Axle adjusting eye
Locknut
Left Side (Brake)
Spacer (medium)
4 With a 10mm wrench, loosen 5 With two 17mm wrenches, 6 Remove wheel. Note the se- Brake plate
both axle adjusters an equal loosen the axle. Slide the wheel quence of the hardware.
amount, approximately five forward to loosen the chain. Spacer (small)
turns. Washer (thick)
Washer (plate cut)
Axle adjusting eye
Locknut
7 Install new chain or wheel by 8 To hook up the brake housing 9 Install the brake spring and
maneuvering the chain onto the anchor, align the cable guide thread the cable wire into the
sprocket and slipping the axle adjuster and install the spacer cable anchor. Thread the cable
into the slots on the frame. and bolt. Do not tighten until to its original position and
final step. tighten securely.
Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers at
www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00AM - 5:00PM Pacific Time.
6