Razor Power A2 инструкция на русском

                          ASSEMBLY AND SET-UP
        Attaching the Handlebars
        Tool Required: 5 mm Allen Wrench
                                                                                             Tighten the screws
to ensure the screw is tightened.
      1. Using the 5 mm Allen wrench       2 Insert the handlebar with the          3 Using the 5 mm Allen wrench
        loosen the handlebar clamp.          throttle facing the rider.                tighten the handlebar clamp.
                                                                                                                                             WARNING: Failure to
                                                                                                                                         properly secure the quick-release
                                                                                                                                         lever may cause the T-bar to
                                                                                                                                         telescope up or down while riding
                                                                                                                                         and may cause you to lose control
                                                                                                                                         and fall.
     4 To adjust the height of the handlebars, open theTqiugichk-ten5tThheetenssciorneofwthesquick-release lever can be adjusted by
        release lever and slide the T-bar to the desired position     manually tightening or loosening the Allen bolt. Be careful not
        and resecure the quick-release lever to lock into place.      to overtighten. You should always be able to open and close
                                                                      the quick-release lever by hand and the T-bar should slide
                                                                      freely when the quick-release is open.
        Collar Clamp
                                         1                                  2                                                                WARNING: Failure toproperly tighten the collar clamp may
                                                                                                                                         allow the handlebars to dislodge
                                                                                                                                         while riding and may cause you to
                                                                                                                                         lose control and fall. When correctly
                                                                                                                                         tightened, the handlebars will not
                                                                                                                                         rotate out of alignment with the front
                                                                                                                                         wheel under normal circumstances.
      3                                  4
                                                                                  5